Restoring Socket CHS Scanner to Factory Defaults

To restore the CHS to its factory defaults, do the following:

Method 1
Step 1

Power on the CHS.

Step 2

While pressing the trigger button, briefly press and release the power button.

Step 3

After about 15 seconds, the CHS will beep. Release the trigger button. If you performed the actions correctly, the CHS will beep 5 times and power off.

Step 4

The next time you power on the CHS, it will take longer than normal. After the CHS finishes powering on, it will have factory default settings (HID mode for Keyboards).

Method 2

Step 1

Print the below barcode from a regular printer.

*IMPORTANT! Print out the page to scan the barcodes. Do not scan them onscreen.

Step 2

Turn on the Scanner and scan the barcode. *It should give a series of 3 beeps then a series of 5 beeps.

Step 3

Turn on the Scanner and it should be ready to pair.